ZR-1 Front Speaker Removal

by Glenn Breitung

Last Update: 07/04/2008

1. Remove the vertical trim strip at the rear of the door opening, 2 Philips head screws.

2. Remove 3 Philips head screws on the outside of the carpeted sill panel.

3. Pull the sill panel up and out of the rubber seal strip at the front of the door opening.

4. The speaker amplifier assembly is attached to the chassis with 4 7 mm hex head sheet metal screws.

5. Disconnect the 4-wire connector and you're done.

6. The amplifier is under an access panel - remove it.

7. Disconnect the multi pin connector and remove the amp circuit board.


	Disclaimer: Repairs and techniques are reported here by amateurs and professionals as an informational opinion service only and should not be attempted by other than factory trained and certified technicians. The ZR1 Net does not recommend anyone doing these procedures and is not responsible for any adverse outcome. Factory repair manuals should always be used and followed to the letter in conjunction with any repair or maintenance performed. All cautions and warnings that appear in the factory manuals apply here as well. As recommended in all service manuals, proper eye and body protection as well as proper tools must be used for any maintenance performed by individuals. Working on automobiles is dangerous and could result in personal and/or property injury. If you do not have the proper tools or know-how, you should not do any of these procedures, but have a qualified technician perform the work.

ZR-1 Net Registry
zr1net@zr1.net